Will BabyDam fit your bath?

Fits all standard UK/EURO baths

BabyDam is designed to fit in any standard, UK/EURO household bath.

 

Yes. BabyDam can be fitted at any point along a standard straight-sided bath. You can fill it with a shower head if you are using it at the non-tap end of the bath. If you do this you will need to remove BabyDam by the normal method with the water still in place.
Yes. You have to soak the suction pads thoroughly to stick to the bath anyway so it will not affect its fitting.
No, there must be a problem in the fitting. For ease, please click here to see the video of how to fit BabyDam correctly. You need to wet the suction pads thoroughly and push down firmly and check the seal round the rubber edging to ensure a watertight seal.
With a newborn it is important to fill it with water to just above the newborn baby's shoulders to keep the infant warm. Once your child is able to sit up, the bath can be filled to a higher depth by fitting one of the plugs supplied into the safety porthole. There is a clear mark on the BabyDam for the recommended maximum water depth to help you.

Step 1.

Wet the suction pads thoroughly.

Step 2.

Don't worry about bending BabyDam. The unique blend of materials used in manufacture makes it super tough.

Step 3.

Hold BabyDam, as shown above, with your palms facing up and thumbs to the front of the faceplate. Line up the BabyDam in the bath above the position where you wish to locate it.

Step 4.

Making sure your BabyDam is square within the bath, PUSH DOWN FIRMLY on the curved handles to flatten the rubber gasket and create an effective seal.

Step 5.

PUSH DOWN FIRMLY on each suction platform to ensure the pads are stuck to the bottom of the bath.

Step 6.

To ensure rubber gasket lip is completely flat, run your finger around front and rear of the gasket to check perfect seal.

Step 7.

Fill bath to required depth.

How to remove BabyDam...

After bathing baby, always empty water before releasing suction pads. Release suction pads one by one by pulling each pull tab upwards to break the seal. Without letting go of the pull tab, lift that side of the BabyDam free from the bottom of the bath with your other hand. Then repeat this process to free the other suction pad. Ensure both suction pads are free before removing BabyDam from your bath.
NEVER USE ABRASIVES.